TM-10-4320-202-15

• OPERATOR, ORGANIZATIONAL, DIRECT AND GENERAL SUPPORT PUMPING ASSEMBLY, FLAMMABLE LIQUID, BULK TRANSFER, 50 GPM (BARNES MODEL 9117CA) ARMY MODEL SPE 16 FSN 4320-728-0265
• SAFETY PRECAUTIONS
• Operator, Organizational, Direct Support and General Support Maintenance Manual is changed as follows
• Figure 3-1. Lubrication Order (Sheet 1 of 2).
• Figure 3-1. Lubrication Order (Sheet 2 of 2).
• APPENDIX A. REFERENCES
• Shipment and Storage
• APPENDIX B. COMPONENTS OF END ITEMS LIST
• Section II. INTEGRAL COMPONENTS OF END ITEM
• APPENDIX E. EXPENDABLE SUPPLIES AND MATERIALS LIST
• Section II. EXPENDABLE SUPPLIES AND MATERIALS LIST
• Table of Contents
• Table of Contents-continued
• CHAPTER 2. INTRODUCTION
• Figure 1-1. Pumping assembly, models 4074CA, 9117CA and 15671CA
• Components
• Differences in Models
• Figure 1-2. Engine and pump base plan.
• CHAPTER 2. INSTALLATION AND OPERATION INSTRUCTION
• Installation or Setting up Instructions
• Section III. CONTROLS
• Starting the Equipment
• Operation in Extreme Heat
• Operation in Dusty or Sandy Areas
• Five Gallon Cans
• Table 2-1. How and Fitting Kit
• Section V. OPERATION OF MATERIEL, USED IN CONJUNCTION WITH THE EQUIPMENT
• CHAPTER 3. OPERATOR AND ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
• Figure 3-1. Lubrication order.
• Figure 3-2. Air cleaner service.
• Section III. PREVENTIVE MAINTENANCE SERVICES
• Figure 3-3. Daily preventive maintenance service.
• Figure 3-4 (1). Quarterly preventive maintenance service.
• Figure 3-4(2)--Continued.
• Section IV. OPERATOR'S MAINTENANCE
• Section VI. FUEL SYSTEM
• Fuel Tank, Bracket, Fuel Strainer, Line and Fittings
• Figure 3-6. Fuel tank, bracket, fuel strainer, line and fittings, removal and installation.
• Governor linkage and Speed Control
• Figure 3-9. Carburetor, exploded view.
• Figure 8-10. Speed control and governor linkage, adjustment, remove and installation.
• Section VII. ENGINE ELECTRICAL SYSTEM
• Figure 3-12. Magneto breaker point, replacement and adjustment.
• Spark Plug and Cable
• Figure 3-14. Magneto timing.
• Section VIII. STARTING PULLEY, SHROUD, AND FLYWHEEL
• Shroud
• Section IX. EXHAUST AND CRANKCASE BREATHER SYSTEMS
• Muffler and Piping
• Figure 3-19.Muffler, exhaust piping and breather, removal and installation.
• Section X. CYLINDER HEAD AND VALVE TAPPET SYSTEM
• Figure 3-20. Cylinder head, removal and installation.
• Figure 3-21. Valve tappet cover, removal and installation.
• Section Xl. HOSES, NOZZLES, AND FITTINGS
• Hoses and Fittings
• Section XII. PUMP ASSEMBLY
• Pump Assembly
• Figure 326. Centrifugal pump, disassembly and reassembly.
• Section XIII. ENGINE
• Section XIV. TOOL BOXES, BASE AND CONTAINER
• Base
• CHAPTER 4. FIELD MAINTENANCE INSTRUCTIONS
• Table 41. REPAIR AND REPLACEMENT STANDARDS-continued
• CHAPTER 5. GENERAL MAINTENANCE INSTRUCTIONS
• CHAPTER 6. ENGINE REPAIR INSTRUCTIONS
• Figure 6-1. Magneto, disassembly and reassembly.
• Section II. VALVES AND VALVE SPRINGS
• Figure 6-2. Valve and valve springs, removal and installation.
• Section III. ENGINE BASE AND OIL PUMP
• Figure 6-3. Engine base and oil pump, disassembly and reassembly.
• Section IV. PISTON AND CONNECTING ROD
• Section V. CRANKSHAFT
• Crankshaft
• Installation.
• Figure 6-8. Crankshaft, disassembly and reassembly
• Section VI. CAMSHAFT AND GOVERNOR
• Section VII. CRANKCASE
• Crankcase
• Figure 6-10. Crankcase, disassembly and reassembly.
• CHAPTER 7. SHIPMENT, LIMITED STORAGE AND DEMOLITION TO PREVENT ENEMY USE
• Demolition by Explosives
• APPENDIX A. REFERENCES
• APPENDIX B. MAINTENANCE ALLOCATION CHART
• Section II. MAINTENANCE ALLOCATION CHART
• APPENDIX C. BASIC ISSUE ITEMS AND MAINTENANCE AND OPERATING SUPPLIES
• Explanation of Columns in the Tabular List of Maintenance and Operating Supplies-Section III
• Section II. BASIC ISSUE ITEMS LIST
• Section III. MAINTENANCE AND OPERATING SUPPLIES
• INDEX
• INDEX-continued
• INDEX-continued
• INDEX-continued
• Blank Page
• Distribution
• TM-10-4320-202-15
• Shared Top Border
• Blank Page
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Blank Page
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Blank Page
• Blank Page
• Blank Page
• Blank Page
• Blank Page
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Shared Bottom Border
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Blank Page
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Shared Left Border

Privacy Statement - Press Release - Copyright Information. - Contact Us