|
|
TM 10-4320-202-15
Figure 3-11. Speed control dissassembly and reassembly.
Section VIl. ENGINE ELECTRICAL SYSTEM
c. Cleaning and Inspection.
3 - 3 0 . General
(1) Clean breaker assembly with approved
The engine electrical system consists of the
dry-cleaning solvent and dry thoroughly with
ignition
components
w h i c h provide the
clean cloth or low pressure air.
electrical spark in the cylinder to ignite the
Caution: Do not allow cleaning solvent
fuel-air mixture when the piston is near top-
to contact the magneto coil. Magneto wind-
dead-center of the compression stroke. The sys-
ings are coated with a substance that is sol-
tem includes the magneto, spark plug, ignition
uble in cleaning solvent.
switch and spark plug lead.
for cracked or
(2) Inspect magneto
3-31. Magneto
threads, or other
damaged case, dents, worn
by hand and check
damage. Turn magneto shaft
a. Breaker Points. Replace and adjust the
the shaft. Replace
for binding and scraping of
magneto breaker points and replace the capaci-
magneto if it is defective.
tor (fig. 3-12).
h a r d w a r e that is
(3) Replace mounting
missing or damaged.
13).
3-15
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |