|
| |
- DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL FOR PUMP, CENTRIFUGAL, POL, GED, 6 IN., 1120 GPM SKID-MOUNTED (BARNES MODEL US67CCG)
- WARNING
- Table of Contents
- Table of Contents-continued
- LIST OF ILLUSTRATIONS
- CHAPTER 1. INTRODUCTION
- Figure 1-1. Centrifugal pump, left front view.
- Differences Between Models
- Identification and Tabulated Data
- Figure 1-3. Wiring diagram.
- CHAPTER 2. DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
- SECTION III. GENERAL MAINTENANCE
- SECTION IV. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS AND AUXILIARIES
- Figure 2-1. Engine removal.
- CHAPTER 3. REPAIR OF ENGINE COMPONENTS
- Fuel Tank
- Figure 3-2. Fuel tank, exploded view.
- Carburetor
- Figure 3-3. Carburetor, exploded view.
- Governor
- Figure 3-4. Governor, exploded view.
- Engine Overspeed Governor
- Figure 3-5. Engine overspeed governor, showing adjusting points.
- SECTION II. REPAIR OF COOLING SYSTEM COMPONENTS
- Radiator
- Figure 3-8. Water pump, exploded view
- Coolant Temperature Safety Switch
- SECTION III. REPAIR OF OIL SYSTEM COMPONENTS
- Figure 3-10. Engine oil filter mounting, exploded view.
- Engine Oil Pressure Safety Switch
- SECTION IV. REPAIR OF ENGINE MOUNTING
- Figure 3-12. Engine mounting parts, exploded view
- Installation-continued
- CHAPTER 4. BASIC ENGINE OVERHAUL
- Table 4-1. Engine Fits, Tolerances, and Wear Limits
- Table 4-1. Engine Fits, Tolerances, and Wear Limits-continued
- SECTION II. ENGINE OVERHAUL
- Figure 4-1. Cylinder head, exploded view.
- Intake and Exhaust Valves
- Figure 4-3. Valves and camshaft, exploded view.
- Cleaning, Inspection, and Repair.
- Figure 4-5. Narrowing valve seat.
- Figure 4-6. Intake and exhaust manifolds, exploded view.
- Oil Pan and Filler Blocks
- Figure 4-7. Oil pan and filler blocks, exploded view.
- Engine Oil Pump
- Figure 4-8. Engine oil pump, exploded view.
- Gear Cover
- Figure 4-9. Gear cover and front end plate, exploded view.
- Flywheel and Flywheel Housing
- Pistons and Connecting Rods
- Figure 4-14. Piston, crankshaft, and flywheel, exploded view.
- Cleaning and Inspection.
- Figure 4-15. Checking piston fit in cylinder bore.
- Main Bearings and Crankshaft.
- Reassembly and Installation.
- Camshaft
- Cylinder Block
- Removal and Disassembly-continued
- Figure 4-22. Cylinder block and flywheel housing, exploded view.
- Cleaning.
- CHAPTER 5. REPAIR OF CENTRIFUGAL PUMP
- Figure 5-1. Suction and discharge assemblies, exploded view.
- Shaft Seal Replacement Replace
- Figure 5-2. Centrifugal pump, exploded view.
- Centrifugal Pump Overhaul
- Reassembly
- APPENDIX A. REFERENCES
- TM-5-4320-258-34
- Shared Top Border
- RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
- Blank Page
- Shared Bottom Border
- Distribution
- Shared Left Border
|
Click
here for thousands of PDF manuals