TM 10-4930-369-13&P
FIELD MAINTENANCE
REPLACE PUMP
INITIAL SETUP:
Tools and Special Tools
Washer, Lock, 0.5 inch (WP 0064, Item 6)
GMTK (WP 0063, Item 7)
Tape, Electrical (WP 0062, Item 23)
Wrench Adjustable, Automotive, 15 Inch (WP 0063,
Washer, Split, 0.375 inch (WP 0064, Item 7)
Item 10)
Wire Marker Book (WP 0062, Item 24)
Wrench Pipe, 18 Inch (WP 0063, Item 12)
Wire, Nuts (WP 0062, Item 25)
Wrench, Torque (WP 0063, Item 13)
Personnel Required
Materials/Parts
Quartermaster and Chemical Equipment
Apron, Rubber (WP 0062, Item 1)
Repairer 91J - 2
Compound, Sealing (WP 0062, Item 6)
Extinguisher, Fire (WP 0061)
References
Gasket (WP 0064, Item 2)
Gloves, Chemical/Oil Protective (WP 0062, Item 10)
Goggles, Industrial (WP 0062, Item 13)
Pail, Utility, 5 Quart (WP 0062, Item 16)
Pan, Drain, 5 gal cap (WP 0063, Item 6)
Equipment Condition
Rag, Wiping (WP 0062, Item 18)
Pump drained (WP 0005)
Spill Kit (WP 0062, Item 20)
FDS disconnected from power source (WP 0005)
Strap, Tie Down (WP 0062, Item 21)
WARNING
Pump weighs 90 pounds and is awkward to remove and install. Two personnel must be used
when removing and installing the pump. Failure to comply may result in injury to personnel.
Personnel must not come in contact with electrical connectors. Failure to comply may result in
injury or death to personnel.
Maintenance must not be performed on equipment that is operating. Failure to comply may
result in injury or death to personnel.
There are pinch points and sharp edges on the FDS cart and pump. Extreme care must be
used when removing and installing the pump. Failure to keep hands clear of pinch points may
result in crushed/severed ingers or similar injury to personnel.
00261
