0024
TM 10-4930-369-13&P
Section 2 Cable Installation
1. Manufacture new section 2 cable (WP 0041).
2. Insert wire-ends of cable (Figure 18, Item 2) through gland nut and gland (Figure 18, Figure 1) on pump motor
electrical enclosure. Feed cable through gland until outer jacket insulation is visible within enclosure.
Figure 18. Insertion of Cable through Gland into Housing.
3.
Connect wires (Figure 19, Item 5) as shown in pump motor wiring diagram (Figure 20) using wire nuts (Figure
19, Item 4) and electrical tape.
002411