TM 10-4930-369-13&P
FIELD MAINTENANCE
MANUFACTURING DISCHARGE HOSE PROCEDURES
INITIAL SETUP:
Tools and Special Tools
Hose (WP 0054, Item 2)
Marker (WP 0062, Item 15)
Clamping Tool, Strap Band, Hose (WP 0063, Item 1)
GMTK (WP 0063, Item 7)
Personnel Required
Materials/Parts
Quartermaster and Chemical Equipment
Repairer 91J
Clamp, Hose (WP 0062, Item 2)
MANUFACTURING DISCHARGE HOSE
1. From bulk hose material, cut a length of hose 25 feet long. Ensure hose ends are cut square.
Figure 1.
Cutting Fuel Hose.
NOTE
Undamaged hose ittings may be salvaged and use to manufacture a new hose assembly.
2.
Inspect the end-itting(s) to be installed on the hose end.
a. If the end-itting has grooves, the bands should be positioned so that they are over the itting grooves when
tight. Using the itting as a template, mark the locations of itting grooves onto the hose.
b. If the end itting does not have grooves, the bands should be positioned so they are evenly spaced over
the itting shank. Using the itting as a template, mark the locations of the bands so they are evenly
spaced over the shank.
00421