Figure 3-2I. Generator regulator removal and installation.

Figure 3-2I. Generator regulator removal and installation.

(2) Inspect the generator for damage; replace a

damaged generator or refer to the proper authority.

Inspect all other parts for cracks, breaks, dents, stripped

threads, or other damage; replace damaged parts.

f. Repair. If the generator has been found defective

and can be corrected with a repair kit refer to figure 3-20

and replace brushes (10) and springs (11).

Note. Replace brushes if less than % inch long.

g. Installation. Refer to figure 3-19 and install the

generator. Observe the following special instructions:

(1) Do not fully tighten the generator mounting

bolts and belt adjusting screw until after the generator belt

has been adjusted.

(2) Refer to figure 3-8 and adjust the generator

belt.

Figure 22. Starting motor removal and installation .

(3) After the generator is reinstalled in the

engine, or at any time after leads have been disconnected

and then reconnected to the generator, the generator must

be repolarized.

3-19