CHAPTER 1. INTRODUCTION - TM-5-4320-243-150009

CHAPTER 1

INTRODUCTION

Section I. GENERAL

1-1. Scope

numbers preceding nomenclature callouts indicate

preferred maintenance sequence.

a. These instructions are published for use by-

d. Report

errors,

omissions,

and

personnel to whom the Reiner Centrifugal Pump, Model

recommendations for improving this publication by the

GP 110-5 is issued. Chapters 1 through 3 provide

individual user is encouraged. Reports should be

information on operation, preventive maintenance

submitted on DA Form 2028 (Recommended Changes

services, and organizational maintenance of equipment,

to DA Publications and forwarded direct to Commanding

accessories, components and attachments. Chapters 4

General, U.S. Army Mobility Equipment Command,

through 7 provide information for direct and general

ATTN: AMSME-MPP, 4300 Goodfellow Boulevard, St.

support and depot maintenance and repair.

Also

Louis, Missouri 63120.

included are descriptions of main units and their

functions in relationship to other components.

e. Report

all

equipment

improvement

recommendations as prescribed by TM 38-750.

b. Appendix A contains a list of publications

applicable to this manual. Appendix B contains a list of

1-2. Record and Report Forms

basic issue items authorized the operator of this

equipment and the list of maintenance and operating

supplies required for initial operation. Appendix C

a. DA Form 2258 (Depreservation Guide for

contains

the

maintenance

allocation

chart.

Vehicles and Equipment).

Organizational, direct and general support and depot

maintenance repair parts and special tools are listed in

b. For other record and report forms applicable to

TM 5-4320-243-20P and 4320-243-35P.

operator, crew, and organizational maintenance, refer to

c. Numbers in parentheses following nomenclature

TM 38-750.

callouts on illustrations indicate quantity;

Note

Applicable forms, exclusive of

Standard Form 46 (United States

Government

Motor

Vehicles

Operator's Identification Card)

which is carried by the operator,

shall be kept in a canvas bag

mounted on the equipment.

Section II. DESCRIPTION AND TABULATED DATA

1-3. Description

necessary for operation are mounted on the control

panel (fig. 1-4).

a. General. The Reiner Centrifugal Pump, Model

GP 110-5 (figs. 1-1, 1-2, 1-3, and 1-4) is a self-

b. Engine. The Continental Engine Model RS633

contained, skid-mounted, gasoline engine-driven pump

is a 6-cylinder, 4-stroke/cycle, liquid cooled, overhead-

unit designed for petroleum pipeline service. The 6-

valve gasoline engine (fig. 1-1) developing 142 rated

cylinder engine (fig. 1-1) is directly connected to the

horsepower at full load speed of 2,200 rpm. When used

pumping assembly (fig. 1-2) by the engine and pump

with the 6-inch flange adapters or the 6-inch Y fittings,

couplings (fig. 1-1). All instruments and controls

the governed engine speed is 2,100 rpm. An

1-1