|
| |
TM 9-2330-398-24
3-27.
ALTERNATOR REPAIR (continued).
21. Using puller set, remove rotor (16) from drive end housing (17
b.
CLEANING AND INSPECTION.
WARNING
Particles blown by compressed air can be dangerous. Be sure to direct air stream away from the user and
other personnel in the area. Failure to do so may result In injury to personnel.
1.
Clean all parts with compressed air.
2.
Inspect bearing (47) in slip ring end housing (15). If
bearing (47) is damaged, remove bearing (47) from
slip ring end housing (15).
3.
Inspect bearing (48) in drive end housing (17). If
bearing (49) is damaged, remove four screws (50),
bearing retainer (48), and bearing (49) from drive
end housing (17).
4.
Inspect all parts for wear, cracks, or other defects.
Replace damaged parts.
c.
ASSEMBLY
NOTE
Perform steps 1 and 2 only if bearing
and bearing retainer were removed from
drive end housing.
1.
Install bearing (49) in drive end housing (17).
2.
Install bearing retainer (48) in drive end housing (17)
with four screws (50).
3-87
|
