|
| |
TM 55-2915-335-30&P
2-17. COVER-END BRUSH HOLDER ASSEMBLY - lNSPECT/REPAIR (Cont)
2-17
f.
g.
h.
TI INSPECT. Check that brush, springs, and leads
are correctly positioned in the holder. Make sure
the brush leads are not wedged in place and that
the brushes are free to move.
Place brush holder cover (2) over studs. Make
sure that brush leads are not wedged between
cover and brush holder. Hold cover down. Install
and tighten nuts (1).
Apply one drop of thread locking compound
(Item 3, Appendix C) to each stud, just above hex
nut. Use cloth to soak up excess locking com-
pound from brush holder studs.
NOTE
FOLLOW-ON TASK Install motor cover (para-
graph 2-16).
END OF TASK
2-53
|
