| |
TM 5-4930-237-10
Table 3-1. Troubleshooting - Continued
Malfunction
Test or Inspection
Corrective Action
ADAPTERS -VALVED
1. FLOW HANDLE FAILS TO OPERATE SMOOTHLY.
Step 1.
Inspect FLOW handle area for signs of dirt or other foreign matter.
Clean area around FLOW handle.
Step 2.
Remove dust cap and inspect interior for dirt or other foreign matter.
Rinse in clean fuel while operating FLOW handle. If parts are missing or damaged, replace
adapter.
2. LEAKAGE FROM END.
Step 1.
Disconnect adapter from 2 inch discharge hose (11). Inspect inside for dust seal.
Inspect dust seal for cuts, tears, or distortion.
If dust seal is missing or damaged, install new dust seal.
Step 2.
Inspect boot for cuts, tears, or distortion.
If hoot is missing or damaged, replace adapter.
3. SEXLESS COMPONENTS WILL NOT LOCK TOGETHER (FLOW HANDLE IN OPEN POSITION).
Disconnect parts. Check interlock pin(s) for damage, distortion, or missing parts.
If interlock pin is damaged or missing parts, replace adapter.
4. DUST CAP DAMAGED OR MISSING.
Inspect dust cap for cracks or distortion.
If dust cap is missing or damaged, replace adapter.
Change 5 3-7
|