|
| |
TM5-4930-237-10
Table 3-1. Troubleshooting - Continued
Malfunction
Test or Inspection
Corrective Action
ELBOW CONNECTOR
1. LEAKAGE FROM END(S).
Step 1. Disconnect hose(s) from elbow connector. Inspect inside for dust seals. Inspect dust seals
for cuts, tears, or distortion.
If dust seals are missing or damaged, install new dust seals.
Step 2. Inspect boots for cuts, tears, or distortion.
If boots are missing or damaged, replace elbow connector.
2. SEXLESS COMPONENTS WILL NOT LOCK TOGETHER (FLOW HANDLES IN OPEN POSITION).
Close FLOW handles and disconnect parts. Check interlock pin(s) for damage, distortion, or
missing parts.
If interlock pin(s) is damaged or missing parts, replace elbow connector.
3. DUST CAP(S) DAMAGED OR MISSING.
Inspect dust cap(s) for cracks or distortion.
If dust cap(s) is missing or damaged, replace elbow connector.
Information on page 3-6 has been deleted.
Change 3
3-5/(3-6 Blank)
|
