|
| |
TMS-4930-235-13&P
Figure 5-6. Nose Sleeve Removal
(c) Remove release pins (29), ball bearings (30), and springs (31) from latch adapter (33).
(20) Remove spring (28) from nozzle body (47).
(21) Remove latch adapter (33) as follows: (See Figure 5-7.)
(a) Insert rod end of regulator tool through bottom of nozzle body (47, Figure 5-2).
(b) Position front plate of regulator tool on end of regulator sleeve (34) with small face down.
(c) Release handle on regulator tool. In this position small face on front plate engages open end of
regulator sleeve (34).
(d) Pull handle down to compress spring (38).
(e) Seat rear plate against nozzle body (47). Insert cotter pin in hole behind rear plate and release
handle.
(f) Remove latch adapter (33) using spanner wrench.
(g) Pull down on handle and remove cotter pin. Let handle slide up slowly to release spring tension.
(h) Remove regulator tool from nozzle body (47).
(22) Remove regulator sleeve (34) and spring (38) from nozzle body (47).
(23) Remove snap ring (35), backup ring (36) and seal (37) from regulator sleeve (34).
5-11
|
