|
| |
TM5-4930-235-13&P
(2)
Slide ring terminal (6) on end of wire rope (7). Crimp ring terminal (6) to wire rope (7).
(3)
Insert other end of wire rope (7) in ground clip (5). Tighten two setscrews (4) on ground clip (5).
f.
Installation.
(1)
Insert capscrew (2) through holes in ring terminals (6 and 11).
(2)
Thread capscrew (2) into nozzle (1) and tighten.
(3)
Perform continuity check from ground clip (5) to latches in nozzle (1) outlet.
4-6. C. (See Figure 4-1).
INITIAL SETUP
This task covers: Removal, Disassembly, Inspection, Replacement, Reassembly, and Installation.
Tools
Common hand tools from automotive shop set.
Materials/Parts
Lint-Free Cloth, MIL-C-85043 (Item 1, Appendix F)
Wire Rope, MIL-W-83420, Type II. Comp B - 3/32 (Figure 2, Appendix G)
a.
Removal.
(1)
Remove capscrew (2) from nozzle (1).
(2)
Remove ground clip assembly (3) and ground plug assembly (8) from nozzle (1).
(3)
Wipe parts with a clean cloth to remove dirt and fuel,
b.
Disassembly.
(1)
Loosen hex nut (9) on ground plug (10) and remove wire rope (12).
(2)
Cut ring terminal (11) from wire rope (12) only if wire rope (12) is not damaged and ring terminal (11)
requires replacement.
c.
Inspection.
(1)
Inspect ground plug (10) for corrosion, cracks, or distortion.
(2)
Inspect wire rope (12) for corrosion, cuts, or fraying.
d.
Replacement. All damaged parts shall be replaced.
Change 1
4-6
|
