|
| |
TM 5-4930-234-13&P
CHAPTER 4
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section I. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT
AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT.
All references to these items can be found in Appendices B through F.
Section II. SERVICE UPON RECEIPT
4-1.
UNPACKING.
a.
Remove any shipping receipts or documents attached to the outside of the container.
b.
Carefully open the container and remove any protective packing material.
c.
Remove nozzle from container.
4-2.
INSPECTION.
a.
Inspect nozzle body for signs of damage or broken parts.
b.
Inspect dust cap, dust plug, ground clip, and ground plug for damage and attachment to nozzle.
c.
Report any damaged or missing parts to your supervisor immediately.
Section III. TROUBLESHOOTING PROCEDURES
4-3.
GENERAL.
a.
This section contains troubleshooting information for locating and correcting most of the operating troubles
which may develop in the nozzle. Each malfunction for an individual component is followed by a list of tests or inspections
which will help to determine corrective actions to take. Perform the tests/inspections and corrective actions in the order
listed.
b.
This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions. If
a malfunction is not listed or is not corrected by the listed corrective actions, notify your supervisor.
4-4.
TROUBLESHOOTING. Table 4-1 lists the common malfunctions which may occur during operation or
maintenance of the nozzle. Perform test/inspections and corrective actions in the order listed.
4-1
|
