SECTION I. INTRODUCTION - TM-5-4930-228-24P0065

TM 5-4930-228-24P

SECTION I

INTRODUCTION

l o w e d by a list of reference numbers appearing

1. Scope

i n all listings, in ascending alpha-numeric se-

a. This manual lists repair parts, special tools,

quence, cross-referenced to the illustration figure

test and support equipment required for the per-

and item number.

f o r m a n c e of organizational, direct support, gen-

eral support, and depot maintenance of the tank

3. Explanation of Columns

and pump unit.

The following provides an explanation of columns

b. Repair parts listed represent those author-

in the tabular lists in sections II and IV.

ized for use at indicated maintenance levels and

a. Source, Maintenance, and Recoverability

w i l l be requisitioned (on an "as required" basis

C o d e s (SMR).

until stockage is justified by demand in accord-

(1) Source code. Indicates the source for the

ance with AR 7102 ).

listed item. Source Codes are:

2. General

Repair parts, special tools and test equipment

This Repair Parts and Special Tools List is di-

supplied from the GSA/DSA, or Army sup-

vided into the following sections:

ply system, and authorized for use at indi-

a. Repair Parts-Section II. A list, in figure

cated maintenance levels.

a n d item number sequence, of repair parts au-

Repair parts, special tools and test equipment

which are procured and stocked for insur-

thorized at the organizational (level for the per-

ance purposes because the combat or mili-

f o r m a n c e of maintenance, including those items

tary essentiality of the end item dictates that

which must be moved for replacement of the

a minimum quantity be available in the sup-

authorized item. Items, except kits and sets, are

ply system.

listed by assembly group in top down breakdown

Repair parts, special tools and test equipment

which are not procured or stocked, as such,

s e q u e n c e . Repair parts kits and sets are listed

in the supply system but are to be manufac-

s e p a r a t e l y at the end of the assembly group to

tured at indicated maintenance levels.

which they belong.

Assemblies which are not procured or stocked

b. Special Tools, Test and Support Equip-

as such, but are made up of two or more

m e n t - S e c t i o n III. Not Applicable.

units. Such component units carry individual

stock numbers and descriptions, are pro-

c. Repair Parts-Section IV. A list, in figure

cured and stocked separately and can be as-

a n d item number sequence, of the repair parts

sembled to form the required assembly at in-

a u t h o r i z e d for the performance of maintenance

dicated maintenance categories.

at the direct support, general support, and depot

Parts and assemblies that are not procured or

l e v e l s , including those items which must be re-

stocked because the failure rate is normally

m o v e d for replacement of the authorized item.

below that of the applicable end item or com-

ponent. The failure of such part or assem-

Items, except kits and sets, are listed by assem-

bly should result in retirement of the end

bly group in top down breakdown sequence. Re-

item from the supply system.

p a i r parts kits and sets are listed separately at

Repair parts which are not procured or

t h e end of the assembly group to which they

stocked. The requirement for such items will

belong.

be filled by the next higher assembly or com-

d . Special Tools, Test and Support Equip-

ponent.

Repair parts, special tools and test equipment

m e n t - S e c t i o n V. Not applicable.

which are not stocked and have no foreseen

e. Federal Stock Number and Reference Num-

mortality. The indicated maintenance level

b e r I n d e x - S e c t i o n V I . A list of Federal stock

requiring such repair parts will attempt to

n u m b e r s in ascending numerical sequence, fol-

obtain the parts through cannibalization or

iii