Section II. MOVEMENT TO A NEW WORKSITE

Section Il. MOVEMENT TO A NEW WORKSITE

2-3. Dismantling for Movement

b. Disconnect and drain the discharge hoses.

Disconnect the nozzles. Install the suction cap (7)

Dismantle the pumping assembly for movement to

and discharge caps (1).

a new worksite as follows:

c. Install the discharge hoses in the hose holders

a. Remove the drain plug (6, fig. 2-1) to drain the

mounted on the pumping assembly frame as shown

fluid from the pump. Reinstall the drain plug.

in figure 1-1. Place the discharge nozzles on top of

the hoses.

d. Disconnect the suction hose from the suction

adapter on the pumping assembly and from the

source of liquid supply. Drain the suction hose and

install the dust cover and plug.

e. Unscrew the mounting bolts that hold the base

of the pump and engine assembly to the top of the

frame assembly. Lift the pump and engine

assembly from the top of the frame and position it

inside the frame as shown in figure 1-1. Secure the

pump and engine assembly to the frame with the

mounting screws.

f. Drape the suction hose around the engine so

that it forms a loop.

2-4. Reinstallation after Movement

Refer to paragraph 2-2 for installation instructions.

Figure 2-1. Pump assembly.

2-2