Section IV. GENERATOR

tension are in balance. The throttle is then in position to

b. Refer to figure 7-3, and disassemble governor in

maintain the desired engine rpm.

the sequence shown by the key numbers. Reassemble in

reverse sequence.

7-6. Disassembly, Reassembly, and Repair

c. Clean, inspect, and repair if required.

a. Remove and install the governor as directed in

d. Adjust the governor after installation as directed

Section IV. GENERATOR

insulated brush holder and the other field lead connects to

7-7. General

the field terminal of the generator.

The generator is a belt-driven, air cooled, self-excited,

externally controlled unit of the two-brush type. One

7-8. Removal and Installation

brush is grounded, with the generator field frame serving

Remove and install the generator, fan, and pulley as

as the return ground conductor in the electrical circuit.

The other brush, mounted in an insulated brush holder, is

connected in the armature terminal of the generator. One

7-9. Disassembly and Reassembly

field lead connects to the

Disassemble the generator as shown in figure

Figure 7-3. Governor, disassembly and reassembly.

7-4