Figure 2-10. Governor removal.

TM 5-4320-234-34

Table 2-1. Troubleshooting - Continued

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

ENGINE CONTINUED

Figure 2-10. Governor removal.

(9) Install gasket (3, fig. 2-10) and governor (2) on gear cover. Sight through the magto mounting hole to check that the

two marked teeth of the governor drive gear engage the single marked tooth of the cam gear as shown in figure 2-11.

Ignitor timing is dependent upon this relationship because the magneto is driven by the governor drive gear. Install

gasket (12, fig. 2-9), gasket plate (11), flatwasher (10) and bolt (9). Tighten the mounting bolt moderately.

2-13