|
| |
3-19.1
Assembly. - Cont'd . Refer to figure 2-38.
e.
Slide one coupling gasket over each cross (10) grooved end.
f.
Align mating surfaces of adapter (1) and cross (10). Pull coupling gasket over sealing surfaces of both pieces.
Ensure gasket is correctly positioned over full circumference of sealing surfaces. Position coupling clamp (3) over
gasket.
g.
While maintaining alignment of mating parts, lock coupling clamp securely.
h.
Repeat steps e. thru g. for remaining adapters (1).
i.
Remove coupling clamps (2, figure 2-39) connecting flanged adapters (3) and gate valves (4) to Y fitting (1).
j.
Slide one 6-inch coupling gasket over each Y (1) grooved end.
k.
Align mating surfaces of adapter (3) and Y fitting (1). Pull coupling gasket over sealing surfaces of both pieces.
Ensure gasket is correctly positioned over full circumference of sealing surfaces. Position coupling clamp (2) over
gasket.
I.
While maintaining alignment of mating parts, lock coupling clamp securely.
m.
Repeat steps j. thru I. for other branch of Y fitting (1).
3-19.2
Installation . Refer to figure 2-61A.
CAUTION
INTERNAL CLEANLINESS
Make sure all hoselines, fittings and valves are clean internally. Foreign materials may disrupt
operations and damage equipment.
NOTE
6-inch hose assembly (10), 6-inch gates valves (11) and elbows (12 and 13) are overpacked
with the 5,000 BBL tanks (1).
a.
Check the position 600 gpm pump installed per paragraph 3-13.
b.
Uncrate 6-inch hose assemblies (2 and 6) and position as shown.
c.
Connect coupling adapters (4) to elbows (12).
d.
Remove protective caps and connect 6-inch discharge hoses (2) to cross assembly (3).
e.
Connect discharge hose (2) between cross assembly (3) and tee (9).
f.
Connect discharge hoses (2) to tee (9). (Hoses connect to transfer hose line set.) g. Connect suction hoses (10)
to fuel tank elbows (13) and gate valves (11).
3-14
|
