|
| |
TM 10-5430-242-12&P 0033 00
0033
00-1
OPERATOR AND UNIT MAINTENANCE MANUAL
(INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
COLLAPSIBLE FABRIC TANKS, FUEL STORAGE,
10,000 AND 20,000 GALLON
BERM LINER DRAIN FITTING ASSEMBLY (GTA MODEL)
SERVICE AND REPAIR
INITIAL SETUP
Tools
Equipment Condition
Tool Kit General Mechanics
Berm liner drain hose assembly removed
(Item 1, WP 0036 00
(WP 0031 00)
Torque Wrench (ft-lb)
(Item 3, WP 0036 00)
Mandatory Replacement Parts
Gasket
Materials/Parts
(Item 6, WP 0044 00)
Detergent
Gasket
(Item 3, WP 0044 00)
(Item 13, WP 0044 00)
Dry Cleaning Solvent
(Item 7, WP 0042 00)
Rags, Wiping
(Item 2, WP 0042 00)
Silicone Compound
(Item 10, WP 0042 00)
DISASSEMBLY
1. Disconnect chain assembly (1) from male disconnect coupling (2) and dust cap (3).
2. Remove dust cap (3) from male disconnect coupling (2) by pulling outward on cam-lever arms (4) and
lifting dust cap (3) from male disconnect coupling (2). Remove and discard gasket (5) from dust cap
(3).
3. Remove eight screws (6) and washers (7) from male disconnect coupling (2) and berm liner (8).
4. Remove male disconnect coupling (2), two gaskets (9), and strainer (10).
5. Discard gaskets (9).
SERVICE
WARNING
Dry cleaning solvent, A-A-59601, used to clean parts, is potentially dangerous to
personnel and property. It produces toxic and flammable fumes. Use only in well
ventilated areas. Avoid repeated and prolonged skin contact. Do not use solvent
near an open flame or near excessive heat. The flash point of the solvent is 100F
to 130F (38 C to 59 C).
CAUTION
Dry cleaning solvent, A-A-59601, used to clean parts, must not come into contact
with any part of the fuel tank fabric. Damage to the fabric will occur.
1. Clean all parts with dry cleaning solvent and dry thoroughly with rags.
2. Clean mating surfaces thoroughly with detergent and hot water.
|
