|
| |
TM 10-5430-242-12&P
0032 00
0032 00-2
CAUTION
Dry cleaning solvent, A-A-59601, used to clean parts, must not come into contact
with any part of the fuel tank fabric. Damage to the fabric will occur.
1. Clean all parts with dry cleaning solvent and dry thoroughly with rags.
2. Clean packing groove thoroughly with detergent and hot water.
3. Inspect all mechanical parts for cracks, dents, breaks, and wear. Replace the component if
unserviceable.
ASSEMBLY
1. Lubricate new o-ring (10) with silicone compound. Position o-ring (10) into the packing groove
located on berm liner (9).
2. Position screen (11) and drain cover plate (6) on berm liner (9) and align the fastening holes.
3. Install drain cover plate (6) to berm liner (9) with eight screws (7) and washers (8), by hand tightening
screws (7).
4. Torque all screws (7) to 15 ft-lb (20.34 N m).
5. Apply sealing compound or anti-seize tape to male disconnect coupling (2) threads.
6. Install dust cap (3) and new gasket (5) on male disconnect coupling (2). Push inward on cam-lever
arms (4) to lock dust cap (3) onto male disconnect coupling (2).
7. Attach chain assembly (1) to male disconnect coupling (2) and dust cap (3).
END OF WORK PACKAGE
3
7
4
6
5
1
2
8
9
10
11
|
