|
| |
TM 10-5430-237-12&P
0005 00
0005 00-5
CAUTION
Do not over-inflate the cover float. Maximum air pressure is 0.5 psi (3.4 kPa).
Cover float may be damaged if over-inflated.
CAUTION
The float may also be inflated by attaching a standard automotive pump to the
automotive valve, but it is not recommended as damage may occur to float.
8. Operate the hand pump or foot bellow to inflate the cover float (5) until firm.
NOTE
A firm touch approximates 0.5 psi (3.4 kPa).
9. Close the inflation valve (2) on the cover float (5) by turning the center part of the valve
counterclockwise, as stenciled on the cover float.
10. Unthread the hand pump/foot bellows hose (1) from the inflation valve (2), disconnect hose from the
hand pump or foot bellows. Store items in the repair pouch.
INITIAL ADJUSTMENTS AND ROUTINE CHECKS (Model GTA-Z60TPW Only)
NOTE
If the tank is cut or punctured during any phase of operation, refer to WP 0006 00 for emergency
repair procedures.
1. Pull tank from perimeter so there are no wrinkles on the bottom of the tank.
2. To avoid damaging tank, kneel down on tank to remove top cover by unsealing from tank.
3. Unseal top opening of tank and look inside tank to check that it is clean and there are no foreign
objects inside.
4. Reseal top tank opening. Make sure seal is smooth with no wrinkles.
5. Replace cover over sealed tank opening. Attach cover to tank, making sure there are no wrinkles.
6. Remove protective wrapping from fittings (6) and (7) and save for repacking after use.
INITIAL ADJUSTMENTS AND ROUTINE CHECKS (Model WT2008 Only)
NOTE
If the tank is cut or punctured during any phase of operation, refer to WP 0006 00 for emergency
repair procedures.
1. Remove the foot bellows and hose from repair pouch. Connect hose to foot bellow.
2. Remove plugs from the two non-return valves (1). Insert foot bellows tube into valve inlet.
|
