| |
TM 10-5430-237-12&P
0005 00
0005 00-4
3. Open the inflation valve (2) by turning the center part of the valve clockwise, as stenciled on the collar
(3).
CAUTION
Do not over-inflate the tank collar. Maximum air pressure is 0.5 psi (3.4 kPa).
Tank collar may be damaged if over-inflated.
CAUTION
The tank collar may also be inflated by attaching a standard automotive pump to
the automotive valve but is not recommended as damage may occur to collar.
4. Operate the hand pump or foot bellows to inflate the collar (3) until firm.
NOTE
A firm touch approximates 0.5 psi (3.4 kPa).
5. Close the inflation valve (2) by turning the center part of the valve counterclockwise (to the left), as
stenciled on the collar (3).
6. Unthread the hand pump or foot bellows hose from the inflation valve (2) on the collar (3) and thread
into the inflation valve (2) in the cover float (5). Insure float is securely attached to cover.
7. Open the inflation valve (2) on the cover float by turning the center part of the valve clockwise (to the
right), as stenciled on the cover float (5).
NOTE: Models 91038 and WT2008
foot bellows not shown.
NOTE: Model 90074 shown.
Others similar
|