|
| |
TM 10-5430-236-12&P
0025 00
0025 00-4
ASSEMBLY - Continued
CAUTIONS
Strapping may break if operator does not release tension on handle when bending
over seal.
Strapping can damage hose if over tightened.
12. Apply pressure to gripper lever (1) and turn handle (2) until strapping (3) is snug. Tool (4) will lock in
place when correct tension is applied. Reposition tool as required.
13. Turn handle (2) to tighten strapping (3) until strapping (3) stops moving through slide seal (5).
14. Reverse handle (2) 3/4-turn, then roll tool (4) to opposite side of slide seal (5). (This will bend
strapping (3) and prevent it from slipping through seal (5) when tool is removed.)
3
1
|
