|
| |
TM 10-5430-236-12&P
0025 00
0025 00-3
ASSEMBLY – Continued
8. Cut a piece of strapping (1) long enough to wrap around hose (2). Allow 12 inches (30.48cm) excess
for sealing. Refer to WP 0035 00 for fabrication of strappings.
9. Slide seal (3) onto strapping (1) and bend strapping end (4) under seal (3).
10. Wrap strapping (1) around hose (2) about one inch (2.54cm) from hose end and slide strapping end
(5) through seal (3).
11. Insert strapping (1) in slot of clamping tool nose (2). Tool nose should fit snug against seal (3).
2
1
3
|
