|
| |
TM 10-4930-241-13
4-6. CHECKING UNPACKED EQUIPMENT - cont.
b.
Processing Unpacked Equipment.
(1)
Remove all tape, paper wrapping, plastic sheeting and packing materials from the AFSSP components.
(2)
Inspect stencils, markings and information plates. All items should be clear and readable.
(3)
Inspect all components to make sure they are in serviceable condition.
(4)
Inspect the equipment for any damage incurred during shipment. If the equipment has been damaged,
report the damage on SF 364, Report of Discrepancy.
(5)
Check equipment against the packing slip to see if the shipment is complete. Report all discrepancies in
accordance with the instructions of DA Pam 738-750.
(6)
Check to see if the equipment has been modified.
Section III. UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
4-7. GENERAL.
To ensure that the AFSSP is ready for use at all times, it must be inspected systematically so that defects may be
discovered and corrected before they result in serious damage or equipment failure.
4-8. PMCS PROCEDURES.
a.
Your Preventive Maintenance Checks and Services, Table 4-1, lists inspections and care required to keep your
equipment in good operating condition.
b.
The "INTERVAL" column of Table 4-1 tells you when to do a certain check or service.
c.
The "LOCATION, ITEM TO CHECK/SERVICE" column of Table 4-1 tells you the name of the item to be checked
or serviced and where the item is located.
d.
The "PROCEDURE" column of Table 4-1 tells you how perform the required checks and services. Follow these
instructions carefully.
4-4
|
