|
| |
TM 10-4930-240-13
4-30. FUELING MANIFOLD ASSEMBLY REPAIR - cont.
(10) Install dust plug (21) in female coupling half (23).
(11) Install split rings (18 and 19) and chain (20).
(12) Install nipple (17) on tee (24).
(13) Install gate valve (16) on nipple (17).
(14) Install nipple (15) on gate valve (16).
(15) Install tee (14) on nipple (15).
(16) Install female coupling half (12) on tee (14).
(17) Install gasket ( 11) in female coupling half (12).
(18) Install dust plug (10) in female coupling half (12).
(19) Install split rings (7 and 8) and chain (9).
(20) Install male coupling half (13) on tee (14).
(21) Install gasket (5) in dust cap (6).
(22) Connect dust cap (6) to male coupling half (13).
(23) Install split rings (2 and 3) and chain (4).
(24) Remove manifold assembly (1) from vise.
f. Installation. Refer to figure 4-18.
(1) Apply foam (9) to saddle of bracket (15).
(2) Position bracket (15) on skid (16).
(3) Install two flat washers (14) cap screws (13), flat washers (12), lockwashers (11) and nuts (10).
(4) Repeat steps (1), (2), and (3) for other bracket (15).
(5) Using two personnel, position fueling manifold assembly (8) on skid (16).
(6) Apply foam (7) to saddle of strap (6)
(7) Aline mounting holes in strap (6) with bracket ( 15).
(8) Install two flat washers (5), cap screws (4), flat washers (3), lockwashers (2) and nuts (1).
(9) Repeat steps (6), (7), and (8) for remaining strap (6).
4-58
|
