| |
TM 10-4320-348-14
4.21 ELECTRICAL CONTROLS AND INDICATORS REPLACEMENT.
This task covers:
a)
Repair
b)
Removal
c)
Installation
INITIAL SETUP
Tools
Equipment
Tool Kit, General Mechanics
Condition
(Appendix B, Section III, Item 1)
Para
Solder Gun
2.7a(2) Sound enclosure assembly removed.
(Appendix B, Section III, Item 2)
Materials/Parts
Solder (Appendix E, Section II, Item 11)
Flux (Appendix E, Section II, Item 12)
Figure 4-9. Electrical Connector and Terminal Block Replacement
NOTE
Always tag and disconnect all wiring attached to any electrical component being
removed before removing component. Refer to tagging during installation for proper
wiring.
a.
Electrical Connector.
(1)
Inspection. (Refer to Figure 4-9)
Inspect the intervehicle connector (1) located at the lower left of the rear sound enclosure panel, for damage.
Replace if damaged.
4-27
|