| |
TM 10-3835-231-13
5-6. FUEL SAMPLING ASSEMBLY REPAIR. - continued
b.
Repair. Replace all defective parts to extent necessary for repair.
c.
Assembly.
(1)
Install four each nuts (12) and flat washers (11) on U-bolts (9).
(2)
Secure sampling table (10) to sampling pipe (13) with two each U-bolts (9) and four each flat washers (8)
and nuts (7).
(3)
Apply antisieze tape to male pipe threads prior to installation.
(4)
Install pipe nipple (6) ball valve (5) needle valve (4) and compression fitting (2).
(5)
Insert tube (3) into compression fitting (2) and center over sampling table (10).
(6)
Tighten compression fitting (2) nut.
(7)
Install plastic caps (1).
5-7
|