Figure 4-33. Tool box, exploded view.
b. Cleaning and Inspection.
(1) Clean the tool box with a cloth dampened
with dry cleaning solvent (fed. spec. P-D-680). Remove
rust with fine sandpaper.
Clean all parts in a well-ventilated
(2) Inspect the tool box for loose or damaged
area. Avoid inhalation of solvent
hinge, latches, or catches, and for cracks and distortion.
Repair or touch up damaged painted areas. Repair or
fumes and prolonged exposure of
replace a damaged tool box.
skin to cleaning solvent.
Installation is the reverse of
exposed skin thoroughly.
removal. Refer to figure 4-33.
cleaning solvent (fed. spec. P-D-680)
used to clean parts is potentially
4-55. Lights and Wiring Harness
a. Removal. Remove the lights and wiring harness
property. Do not use near open
as shown in figure 4-34.
flame or excessive heat. Flash point
of solvent is 100° to 138°F (38° to