|
| |
4.13.11.1 Removal.
To prevent rolling or sliding, do not work on equipment that is not
s e c u r e l y s t a b i l i z e d.
Ensure both wheels are secure.
Failure to obey this
warning may result in serious personnel injury.
a .
Remove four screws (figure 4-51, 1), lockwashers (2), one cover (3), and one
g a s k e t ( 4 ).
b .
Tag and disconnect three leads (5) and two jumper wires (6) .
c .
Remove two lock nuts (7), washers (8), screws (9), ground strap terminal (10),
and relay (11) .
d .
Remove four screws (12) and box (13).
e .
Remove eight nuts (14), lockwashers (15), screws (16), one ground strap (10),
and four mounts (17).
4.13.11.2 Installation.
a.
b .
c .
d.
e .
f .
Install four mounts (17), ground strap (10),
eight screws
(16), lockwashers
(15), and nuts (14).
Install box (13) and screws (12).
Install relay (11), ground terminal (10), two screws (9), washers (8), and
lock nuts (7).
Connect two jumper wires (6) and three leads (5).
Install new gasket (4).
Install cover (3), four lockwashers (2), and screws (1).
4-96
TM 10-4320-343-14
|
