|
| |
TM 10-4320-343-14
4.14 REGULATOR ASSEMBLY MAINTENANCE (Regulated Model ADC1500 only).
4.14.1 Pressure Regulator Cable Assemblies Maintenance.
This task covers: 4.14.1.1 Removal
4 .
1
4 .
1 .3
I n s t a l l a t i on
INITIAL SETUP
Tools
Equipment Conditions
General Mechanic’s Tool Kit (appendix B,
Equipment shut down, refer to
Section III, Item 1)
paragraph 2.5.1.2 or 2.5.2.2.
General Safety Instructions
Material/Parts
To prevent rolling or sliding, do not
Tags (appendix E, Section II, Item 12)
work on equipment that is not securely
Lockwashers (TM 10-4320-343-24P)
s t a b i l i z e d.
Do not work on equipment without
following standard shop safety
precautions.
4.14.1.1 Removal.
To prevent rolling or sliding, do not work on equipment that is not
s e c u r e l y s t a b i l i z e d.
Ensure both wheels are secure.
Failure to obey this
warning may result in serious personnel injury.
a .
Tag and disconnect wires (figure 5-52, 1, 2, 3, and 4) and zener diode (5)
from terminal board (TB1).
b .
Disconnect the four pin connector (6) from pressure controller (7).
c .
Remove clamp (8) and cable (9).
d .
Disconnect the six pin connector (10) from pressure controller (7).
e .
Disconnect the two pin connector (11) from the magnetic pickup (12).
f .
Disconnect the ten pin connector (13) from control box (14) and remove
c a b l e ( 1 5 ).
4.14.1.2 Installation.
a .
Position cable (15) in place and connect the ten pin connector (13) to control
box (14) .
b .
Connect the two pin connector (11) to the magnetic pickup (12) .
c .
Connect the six pin connector (10) to the pressure controller (7).
d .
Position cable (9) in place and install clamp 8.
e .
Connect four pin connector (6) to pressure controller (7).
f .
Connect the zener diode (5) and wires (4, 3, 2, and 1) to terminal
board (TB1).
4-97
|
