|
| |
TM 9-2330-398-24
APPENDIX G
LUBRICATION INSTRUCTIONS
Paragraph
Page
Number
Paragraph Title
Number
G-1
General ............................................................................................................................ G-1
G-2
Specific Lubrication Instructions....................................................................................... G-1
G-1. GENERAL.
NOTE
These instructions are MANDATORY.
a.
The M969A2 semitrailer must receive lubrication with approved lubricants at recommended intervals in order to be
mission-ready at all times.
b.
The KEY lists lubricants to be used in all temperature ranges and shows the intervals.
c.
The Lubrication Chart shows lubrication points, items to be lubricated, required lubricant, and recommended
intervals for lubrication. Any special lubricating instructions required for specific components are contained in the
NOTE section of the chart.
d.
Recommended intervals are based on normal conditions of operation; under extreme conditions, lubricants should
always be changed more frequently. When in doubt, notify your supervisor.
G-2. SPECIFIC LUBRICATION INSTRUCTIONS.
a.
Keep all lubricants in a closed container and store in a clean, dry place away from extreme heat. Keep container
covers clean and do not allow dust, dirt, and other foreign material to mix with lubricants. Keep all lubrication
equipment clean and ready to use.
b.
Maintain a record of lubrication performed and report any problems noted during lubrication. Refer to DA Pam
738-750 for maintenance forms and procedures to record and report any findings.
Wipe excess lubricant from the area of brakeshoe linings to prevent grease from
soaking the linings. If brakeshoe linings become soaked, have Unit maintenance
replace them. Failure to follow this warning may cause brakes to malfunction,
resulting In serious injury or death to personnel.
c.
Keep all external parts not requiring lubrication free of lubricants. After lubrication, wipe off excess oil or grease to
prevent accumulation of foreign matter.
d.
Refer to FM 9-207 for lubrication instructions in cold weather.
e.
After operation in mud, sandy, or dusty conditions, clean and inspect all points of lubrication for fouled lubricants.
Change lubricants as required.
G-1
|
