|
| |
TM 9-2330-398-24
4-1.
ENGINE ASSEMBLY REPAIR (continued).
30.
Install ball (123) and thrust bearing (124) in gear cover (51).
31.
Install new oil seal (126) and needle bearing (125) in gear cover (51).
32.
Install new seal (122) in gear cover (51).
33.
Install governor shaft (128) in gear cover (51).
34.
Install governor yoke (129) on governor shaft (128) with smooth face of yoke facing away from gearcover (51), and
secure with retaining ring (127).
35.
Pack cavity of seal (122) with grease.
NOTE
•
Tape keyway and sharp edges on crankshaft to protect the seal during installation.
•
Before tightening screws, make sure stop pin is in governor cup.
4-28
|
