|
| |
TM 9-2330-398-24
4-1.
ENGINE ASSEMBLY REPAIR (continued).
26.
Install key (65) on camshaft (66), and press on gear (64) to install retaining ring (63) on camshaft (66).
27.
Install camshaft (66) in cylinder block (38). Align timing marks on camshaft gear and crankshaft gear (72). Pry up
crankcase gear (72) and measure gap between camshaft gear and crankshaft retainer washer (71). Gap should
be between 0. and 0.039 inch (0.018 and 0.099 cm).
28.
Fill flyball recesses on governor cup (67) with grease, and install flyballs (69) in governor cup (68).
29.
Position governor cup (68) on center pin of camshaft (66), and install retaining ring (68) on center pin of camshaft
(66).
4-27
|
