| |
TM 9-2330-398-24
3-26.
ENGINE SHROUDING REPLACEMENT (continued).
m. BLOWER HOUSING INSTALLATION
NOTE
Make sure starter shroud is attached to
blower housing.
1.
Install blower housing (35) on engine with six screws
(37) and new lockwashers (36), two screws (27) and
washers (28), and screw (29).
2.
Install blower housing grille (33) on blower housing
(35) with grille retainer (33), washer (32), new
lockwasher (31), and screw (30).
3.
Tighten screw (29).
4.
Install engine fan shroud (7) on frame (8) and
support (3) with four screws (4), washers (6), and
new self-locking nuts (5).
n.
TOP AIR HOUSING COVER INSTALLATION
1.
Install top air housing cover (12) on engine with four screws (14) and washers (13) and two spring nuts (38).
2.
Install lifting bracket (15) and lifting bracket brace (26) on engine with two screws (17), washers (18), vibration
cushions (19), and spacers (20).
3.
Install spacer (23) on top air housing cover (12) with new lockwasher (22) and screw (21).
4.
Install muffler tray (9) on two supports (3 and 2) with five screws (1), washers (11), and new self-locking nuts (10).
FOLLOW-ON MAINTENANCE:
Install muffler and exhaust pipe (para 2-99).
Connect air cleaner hose at intake manifold (para 2-96).
Install fuel lines on fuel tank (if Installing blower housing) (para 2-97).
Install throttle cable at engine (if installing rear cylinder housing) (para 3-23).
Install governor linkage assembly (if Installing bottom cylinder pan) (para 3-24).
Connect engine fuel lines (if installing bottom cylinder pan) (para 2-98).
Install engine high-temp thermostatic control switch (para 3-28).
Install engine throttle and choke linkage (para 3-23).
3-83
|