Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: Section III. REAR AXLE MAINTENANCE
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

TM 9-2330-398-24 Section III.  REAR AXLE MAINTENANCE Paragraph Page Number Paragraph Title Number 3-8 General ................................................................................................................................................ 3-30 3-9 Axle Replacement ............................................................................................................................... 3-30 3-10 Bogie Assembly Replacement............................................................................................................. 3-32 3-8.  GENERAL. This section describes and illustrates removal and installation procedures for the rear axle and bogie assemblies. 3-9.  AXLE REPLACEMENT. This Task Covers: a.  Removal b.  Installation Initial Setup: Tools/Test Equipment: •  Air reservoirs drained (refer to TM 9-2330-398-10). •  Common No.  1 tool set (Item 1, Appendix B) •· Tire and wheel assemblies removed (para 2-62). •· General mechanic's tool kit (Item 4, Appendix B) •  Hub and brakedrum assemblies removed (para 2-63). •  Lifting device (Item 6, Appendix B) •· Brake air chambers removed (para 2-51). •· Semitrailer bonded and grounded (refer to Equipment Conditions:  TM 9-2330-398-10). •· Semitrailer parked on hard level surface (refer to TM 9-2330-398-10). Personnel Required: Two •· Semitrailer uncoupled (refer to TM 9-2330-398-10). a. REMOVAL 1.    Using lifting device, raise rear of semitrailer until weight of both suspension springs (4) has been removed from axle (5).  Support or crib semitrailer frame securely. 2.    Position and raise two jacks to support axle (5).  Remove supports or cribbing from under axle (5). 3.    Remove four nuts (7), washers (8), and screws (1) from spring end cap (11) and spring seat (9) on axle (5). 4.    Remove four nuts (2), eight washers (3), and two U-bolts (6) from spring seat (9) and spring end cap (11) on axle (5). 5.    Remove spring seats (9) and two cushioning pads (10) from axle (5). 6.    Repeat steps 3 through 5 for other side of axle (5). 7.    Using jacks, slowly lower and remove axle (5) from under semitrailer. 3-30

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business