|
| |
TM 9-2330-398-24
Section XIII. SPECIAL PURPOSE KITS MAINTENANCE
2-113. VAPOR RECOVERY SYSTEM REPLACEMENT.
This Task Covers:
a. Removal of Hood and Hose
b. Installation of Hood and Hose
c. Removal of Piping
d. Installation of Piping
e. Removal of Ground Receptacle
f. Installation of Ground Receptacle
Initial Setup:
Tools/Test Equipment:
•
Gasket (2) (Item 50, Appendix F)
•
General mechanic's tool kit (Item 4,
•
Seal (Item 153, Appendix F)
Appendix B)
•
Self-locking nut (8), (Item 171, Appendix F)
•
Common No. 1 tool set (Item 1,
•
Self-locking nut (12) (Item 172, Appendix F)
Appendix B)
•
Self-locking nut (10) (Item 173, Appendix F)
•
Self-locking nut (2) (Item 177, Appendix F)
Materials/Parts:
•
Petrolatum (Item 24, Appendix C)
Equipment Conditions:
•
Gasket (Item 20, Appendix F)
•
Semitrailer uncoupled (refer to TM 9-2330-398-10).
•
Gasket (Item 39, Appendix F)
•
Semitrailer bonded and grounded (refer to
•
Gasket (2) (Item 49, Appendix F)
TM 9-2330-398-10).
a.
REMOVAL OF HOOD AND HOSE
1. Loosen clamp (15) on hood (12).
2. Loosen hose clamp (7). Slide off clamp (15),
hose (8), and hood (12), as a unit, from
semitrailer.
3. Loosen two hose clamps (9 and 11), and remove
hose (8) and pipe (10) from hood (12).
4. Loosen clamp (14), and remove plug (13) from
hood (12).
5. Remove four screws (16), adapter (6), and
gasket (5) from semitrailer. Discard gasket.
6. Remove six screws (4) and self-locking nuts (1),
adapter (2), and gasket (3) from I semitrailer.
Discard self-locking nuts and gasket.
2-247
|
