|
| |
TM 9-2350-253-34-2
2-81. TOOL BOX ASSEMBLY REPAIR.
This task covers:
a.
Removal
b.
Disassembly
c.
Cleaning and Inspection
d.
Assembly
e.
Installation
Initial Setup:
Tools/Test Equipment:
Equipment Conditions:
•
General mechanic's tool kit (Item 4, Appendix B)
•
Semitrailer uncoupled (refer to TM 9-2330-398-10).
•
Emergency valve A handle control cable
Materials/Parts:
disconnected (para 2-133).
•
Self-locking nut (Item 166, Appendix F)
•
Tool box emptied (refer to TM 9-2330-398-10).
•
Self-locking nut (2) (Item 168, Appendix F)
•
Semitrailer bonded and grounded (refer to
•
Self-locking nut (9) (Item 172, Appendix F)
TM 9-2330-398-10).
•
Self-locking nut (Item 176, Appendix F)
a.
REMOVAL
CAUTION
To avoid damage to equipment and Injury to personnel, place support under tool box
before removing mounting screws.
1.
Remove two screws (6 and 8) and self-locking nuts (4 and 9) from tool box (5). Discard self-locking nuts.
2.
Remove two screws (13 and 15), washer (14), and two self-locking nuts (11 and 12) from tool box (5) and
emergency valve A control handle bracket (10). Discard self-locking nuts.
NOTE
Tool box may be tack welded in position. Do not reweld when installing tool box.
3.
Remove four mounting screws (22) and self-locking nuts (21) and tool box (5) from semitrailer. Discard self-
locking nuts.
b.
INSTALLATION
1.
Remove two screws (2) and self-locking nuts (7), and angle brackets (3) and cover (1) from tool box (5).
Discard self-locking nuts.
2.
Remove screw (24) and self-locking nut (23) and catch (25) from cover (1). Discard self-locking nut.
3.
Remove screw (16) and rubber catch (17) from bracket (19).
4.
Remove two screws (18) and self-locking nuts (20) and bracket (19) from tool box (5). Discard self-locking
nuts.
c.
CLEANING AND INSPECTION
1.
Inspect parts for cracks, bends, or damage. Replace defective parts. .
2-176
|
