|
| |
S e c t i o n X V I . P A I N T I N G A N D
TM 9-2330-272-14
I D E N T I F I C A T I O N
M A R K I N G
4-106. PAINTING AND IDENTIFICATION MARKING.
a. Painting. Refer to TM 43-0139 for instructions on painting the M131 Series Semitrailers.
b. Stencil Markings.
For location
NOTE
and contents of stencil markings refer to paragraph 1-8.
(1) If stencil markings are not legible, stencil must be repainted. Paint numerals or letters in simple
block type, using black paint.
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open frame or excessive heat.
The solvent’s flash point is 100°F-138°F (38°C-59°C). If you become dizzy while
using cleaning solvent, immediately get fresh air and medical help. if solvent contacts
eyes, immediately wash your eyes and get medical aid.
(2) Before applying paint, clean all surfaces to be stenciled with dry cleaning solvent (Item 16,
Appendix E). Dry thoroughly.
WARNING
Avoid excessive inhalation of vapors when stenciling. All stenciling procedures must
be performed in a well-ventilated area. A fire extinguisher must be on hand. Failure to
follow this warning may result in injury to personnel.
Personnel must wear protective face masks if spraying paint. If face masks are not
available, paint with brush only. Personnel must stay clear of work area where spray
painting is taking place. Failure to follow this warning may result in injury to
personnel.
(3) Apply paint to stencil with dabbing motion.
(4) Allow paint to dry for 24 hours.
4-229
|
