|
| |
TM 55-2915-335-30&P
2-23. ELECTRICAL CIRCUITS - lNSPECT/REPLACE (Cont)
2-23
2. REMOVAL
a.
b.
c.
Remove defective brush circuit only. Use knife to
cut shrink tube (1) and secondary lead (2) from
mounting stud (3). If worn through or cracked,
remove short piece of shrink tube (4) from base of
mounting stud (3). If replacing negative secondary
brush circuit, cut positive terminal lead wire and
lug terminal (5) from primary lead.
If secondary brushes (6) are good, unsolder defec-
tive secondary lead from brush. Discard defective
secondary lead and attached components.
If positive terminal lead circuit is defective,
remove and replace positive terminal (7) per the
instructions and illustrations in paragraph 2-24.
GO TO NEXT PAGE
2-81
|
