|
| |
TM 55-2915-335-30&P
2-21. PUMP COVER AND INLET SEAL - lNSPECT/REPAIR/REPLACE (Cont)
2-21
4. INSTALLATION
a.
b.
Install new packings (5 and 7) on pump cover (4)
and inlet seal (6). Apply a thin, even coating of
white petrolatum (Item 6, Appendix C) to pack-
ings.
Place inlet seal (6) on pump cover (4). Slide pump
cover and inlet seal into inlet port of housing (2).
Rotate pump cover while installing. Insert pump
cover and inlet seal until fully seated. Once seated,
be careful not to disturb position of pump cover or
inlet seal.
c. Install retaining ring (1). Place one end of retain-
ing ring in groove. Hold end in place. Use index
finger to spiral ring into groove.
NOTE
FOLLOW-ON MAINTENANCE: Clean, visual inspect, and install
impeller, armature, and field tube (paragraph 2-18).
END OF TASK
2-75
|
