|
| |
TM5-4930-237-10
c.
d.
Inspection.
(1) Inspect dust seal (3) for cuts, tears, or distortion.
(2) Dust Seal (3) Shall be replaced if damaged.
Installation.
(1) Insert a dust seal (3) in groove of body (2) and dust cap (1).
(2) Using a fingertip, push around outside edge to seat dust seal (3) in groove.
(3) Install dust cap (1) on body (2).
LEGEND
1. DUST CAP
2. BODY (TYPICAL)
3. DUST SEAL
14791A
3-5. D1 Nozzle Strainer. (See Figure 3-2.)
INITI.AL SETUP
This task covers: Removal, Cleaning, lnspection. and Installation
None Required.
Material/Parts
Lint-Free Cloth, MIL-C-85043 (Item 1, Appendix D)
3-13
|
