|
| |
TM5-4930-237-10
Table 3-1. Troubleshooting - Continued
Malfunction
Test or Inspection
Corrective Action
D1 NOZZLE - Continued
5. DUST CAP DAMAGED OR MISSING.
Inspect dust cap for cracks or distortion.
If dust cap is missing or damaged, replace D1 nozzle.
Section III. MAINTENANCE PROCEDURES
3-3. General. This section contains maintenance procedures which are the responsibility of the operator.
3-4. Dust Seal. (See Figure 3-1.)
INITIAL SETUP
This task covers: Removal, Cleaning, Inspection, and Installation
Tools
None Required.
Materials/Parts
Lint-Free Cloth, MIL-C-85043 (Item 1, Appendix D)
a. Removal.
NOTE
A suitable container should be available to catch fuel spillage.
(1) Remove dust cap (1) from body (2).
(2) Remove a dust seal (3) from body (2) and dust cap (1).
b. Cleaning. Wipe dust cap (1), body (2), and dust seal (3) with a clean cloth to remove dust, dirt, or fuel.
3-12
|
