|
| |
TM5-4930-237-10
Table 3-1. Troubleshooting - Continued
Malfunction
Test or Inspection
Corrective Action
3 INCH DISCHARGE HOSE - Continued
2. LEAKAGE FROM CAMLOCK END.
Step 1. Disconnect hose from tee connector. Inspect inside for gasket. Inspect gasket for cuts,
tears, or distortion.
If gasket is missing or damaged, replace 3 inch discharge hose.
Step 2. Inspect cam arms for damage or distortion.
If cam arms are damaged, replace 3 inch discharge hose.
3. LEAKAGE FROM SEXLESS END.
Step 1. Disconnect hose from tee connector. Inspect inside for dust seals. Inspect dust seals for
cuts, tears, or distortion.
If dust seals are missing or damaged, install new dust seals.
Step 2. Inspect boot for cuts, tears, or distortion.
If boot is missing or damaged, replace 3 inch discharge hose.
4. LEAKAGE FROM HOSE.
Inspect hose for cracks, abrasions, or damage.
If damage extends through hose, replace 3 inch discharge hose.
5. SEXLESS COMPONENTS WILL NOT LOCK TOGETHER (FLOW HANDLES IN OPEN POSITION).
Close FLOW handles and disconnect parts. Open FLOW handle (on hose) and see if interlock pin
extends.
If interlock pin does not extend or is damaged, replace 3 inch discharge hose.
6. DUST CAP DAMAGED OR MISSING.
Inspect dust cap for cracks or distortion.
If dust cap is missing or damaged, replace 3 inch discharge hose.
3-2
|
