| |
TM5-4930-235-13&P
(15) Install latches (25) and endless spring (26) as follows:
(a) Install one latch (25) in groove of latch adapter (33).
(b) Hold pullback sleeve (27) and push down on release pins (29).
(c) Allow pullback sleeve (27) to slide up slowly and contact heel of latch (25) to hold pullback sleeve
(27) in position.
(d) Install remaining five latches (25) in grooves of latch adapter (33).
(e) Roll endless spring (26) over latches (25) and into groove of latch adapter (33).
CAUTION
Do not use an extension or cheater bar with spanner wrench. Failure to comply can result in
damage to parts.
(16) Thread nose sleeve (24) on pullback sleeve (27) and tighten using spanner wrench.
(17) Place spring (23) on inside shoulder of latch adapter (33).
(18) Install safety sleeve (22) over spring (23).
(19) Slide stem (21) through safety sleeve (22).
(20) Push down on pullback sleeve (27) until release pins (29) engage.
(21) Install stem tool as follows: (See Figure 5-3.)
(a) Insert forward pins of stem tool in holes of stem (21, Figure 5-2).
CAUTION
Push down on stem tool carefully to prevent damage to seal.
(b) Push down on stem tool to compress spring (23) and slide safety sleeve (22) through seals (1 and
32).
(c) When stem tool is almost completely inserted, align rear pins of stem tool with slots in nose sleeve
(24).
(d) Continue to push down until latches (25) engage stem tool.
NOTE
Do not push down on pullback sleeve or stem tool will fall out.
(22) Turn nozzle body (47) in vise so that outlet end is pointing down.
5-18
|