|
| |
TM5-4930-235-13&P
(7) Install stem tool as follows: (See Figure 5-3. )
(a) Put handle (11, Figure 5-2) in FLOW (on) position. Push pullback sleeve (27) down to latched
position.
(b) Insert forward pins of stem tool in holes of stem (21).
(c) Put handle (11) in no flow (off) position and insert rear pins of stem tool in slots on face of nose
sleeve (24).
(d) Push down on stem tool until latches (25) engage stem tool.
NOTE
Do not push down on pullback sleeve or stem tool will fall out.
Figure 5-3. Stem Tool Installation
(8) Remove end cap (3) and related parts as follows:
(a) Position nozzle body (47) in vise with end cap (3) pointing up.
5-7
|
