|
| |
TM 54930-235-13&P
c. 1. Inspection. (Unisex model 125-0505)
(1) Inspect dust plug (18) for corrosion, cracks, or distortion.
(2) Inspect O-ring (19) in dust plug (18) for cuts, tears or distortion.
(3) Inspect wire rope (17) and sleeves (15) for corrosion, cuts or fraying.
(4) Inspect O-ring (30) found in coupling (20) for cuts, tears, or distortion.
(5) Inspect coupling (20) for cracks, distortion, or evidence of leakage.
(6) Inspect strainer body (21) for cracks or distortion.
(7) Inspect strainer (22) for cracks or distortion.
(8) Inspect O-ring (23) for cuts, tears, or distortion.
(9) Inspect strainer housing (24) for cracks, distortion, or evidence of leakage.
d. Replacement (Cam-Lock). All damaged parts shall be replaced.
d. 1. Replacement (Unisex model 125-0505). All damaged parts shall be replaced.
e. Reassembly (Cam-Lock).
(1) Apply a light, even coat of thread sealing compound to threads of strainer housing (24).
CAUTION
Do not over tighten. Failure to comply can result in damage to parts.
(2) Thread strainer housing (24) into nozzle (1) until one to three threads are exposed. Wipe off excess
thread sealing compound.
CAUTION
Strainer must be installed carefully to prevent damage to O-ring.
(3) Place O-ring (23) and strainer (22) inside strainer housing (24).
(4) Apply a light, even coat of thread sealing compound to threads of coupling half (20).
CAUTION
Do not over tighten. Failure to comply can result in damage to parts.
(5) Clamp coupling half (20) in a vise. Thread strainer body (21) on to coupling half (20) until one to three
threads are exposed. Wipe off excess thread sealing compound.
(6) Thread strainer body (21) into strainer housing (24). Hand-tighten only.
(7) Place gasket (19) inside coupling half (20).
Change 1
4-8
|
