|
| |
TM5-4930-235-13&P
Table 4-1. Troubleshooting - Continued
Malfunction
Test or Inspection
Corrective Action
6. LEAKAGE AT OUTLET END.
Step 1. Inspect outlet end for dirt, foreign matter, or damage.
Remove dirt or foreign matter with a clean cloth. If there is any sign of damage send nozzle to Direct
Support for overhaul.
Step 2. Press on end of vacuum break valve stem to check for free movement.
If it doesn't move freely or there is any sign of damage send nozzle to Direct Support for overhaul.
Section IV. MAINTENANCE PROCEDURES
4-4. General. This section contains maintenance procedures which are the responsibility of Unit Level Maintenance.
The nozzle must be removed from the fuel hose before performing these procedures. Refer to paragraph 3-3 for details.
4-5. Ground Clip Assembly. (See Figure 4-1).
INITIAL SETUP
This task covers: Removal, Disassembly, Inspection, Replacement, Reassembly, and Installation.
Tools
Common hand tools from automotive shop set.
Materials/Parts
Lint-Free Cloth, MIL-C-85043 (Item 1, Appendix F)
Wire Rope, MIL-W-83420, Type 11, Comp B - 3/32 (Figure 2, Appendix G)
a.
Removal.
(1)
Remove capscrew (2) from nozzle (1).
(2)
Remove ground clip assembly (3) and ground plug assembly (8) from nozzle (1).
(3)
Wipe parts with a clean cloth to remove dirt and fuel.
b.
Disassembly.
(1)
Loosen two setscrews (4) on ground clip (5) and remove wire rope (7).
(2)
Cut ring terminal (6) from wire rope (7) only if wire rope (7) is not damaged and ring terminal (6)
requires replacement.
4-3
|
